Before we begin exploring the user interface of the 9380 used to control how the wire is processed we must first learn to properly load raw material into the machine. Refer to the Cut List found near the machine to determine which raw cable material is to be processed. Open the safety cover, and turn the feeding unit opener clockwise to the open position. Ati radeon graphics drivers for windows 7 32 bit. Do not attempt to turn the feeding unit opener past the locked open position as it will damage the unit. Select the appropriate guides for the raw material selected. The wire must slide freely through the guides. Immovable Guide Left & Right • Open the Safety Cover • Push the Lever (1) downwards • Remove the Guide (2) from the holder • Grasp the required guide so that the flat surface (3) is positioned upwards • Push the Guide into the holder -The lever (1) must snap in Swivel Guide • Loosen the thumb screw (1) • Grasp the guide (2) and remove it from the holder • Slide the required guide (2) into the holder • Tighten the thumb knob (1). The powerful EcoStrip 9320 processes round cables up to 9 mm (0.35) O.D. And flat ribbon cables up to 13 mm (0.51) width with pull-off lengths up to 100 mm. Load the spool of raw cable material onto the cable reel holder of the PreFeeder, with the spooling direction of the reel facing counter-clockwise. Hd movie download torrent. Lock in place with the centering cones. Make sure the cable reel will spin freely. Open the Quick Lock on the PreFeeder’s transport unit by flipping the toggle upwards. Feed the raw material through the transport unit. Turn the top and bottom locking levers on the accumulator rollers clockwise to open. The diagram, also visible on the Operator Panel, shows how the raw material is routed through the Accumulator. Route the cable around the Accumulator lower dancer roller first, counter-clockwise, and then around the top guide roller before again passing the lower roller. For smaller gauge wire (16AWG), the additional weight is used. See picture for installation of the additional weight. Lift up the Wire End Monitoring Switch and feed the raw material through the first guide, and then between the left feed rollers. Feed the raw material through the swivel guide until a small amount of wire can be seen at its right end near the blades. Do not feed through or past the blades. Close the feeding unit opener by turning the lever counter-clockwise. Close the safety cover. Lightly tension the cable in the PreFeeder by hand-spinning the spool clockwise, and then lock the transport belts with the Quick Lock. If the Quick Lock is too difficult to engage you must first loosen the Adjuster Knob on top of the PreFeeder’s Transport Unit. Tighten the Adjuster Knob until the transport belts have firm grip on the raw material and will not allow it to slip. On the touch screen display, select the raw material loaded in order to access the Production Commands Menu. The gap between the right feed rollers must be adjusted whenever there is a change in raw material in order to ensure accurate processing of the wire. This gap is adjusted manually however with guided assistance through the Graphical User Interface. Select the Production Commands Menu (see picture) In the menu that appears, select “Adjust” (see picture) In the opened dialogue, press “Feed” until wire is present between the right feed rollers. Follow the on screen prompts until the adjustment is complete. The wire used to adjust is then automatically cut and ejected, giving us a proper “Zero Cut” to begin processing from. Those of us who have had the hardware key license, in some cases for nearly 20 years, were NOT advised of this at the time we were asked to purchase another maintenance agreement, which is deliberate misrepresentation. If you've been using one, you already know. Wave function spartan tutorial. Obviously, users who chose the hardware key option thought they had good reasons for doing so. I won't take the time to list all of the reasons why I think a hardware key is infinitely preferable to the activation code option.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2019
Categories |